Task 6 - Developed 3D Samples

To start off my final project i made the shape of the body out of cardboard

I then used paper mache to cover the body. This brought the body all together and made it look much neater.

Next thing that i made was the pincers that belong on the front of my minibeast. To make the pincers i got strips of cardboard and curled it up and put it on top of more rolled cardboard which was put together with tape.

this is what the body and pincers look like together

Next i used modroc on top of the cardboard pincers to keep them together and make them more solid than they were. 

Next i decided to curl up some paper into a ball and glue it at the middle top of the body and then used paper mache to connect it properly. this was designed to be a eyeball. I then taped the open shell/wings onto the body.

To finish off the design i paper mached the wings and body together but there was some problems because the cardboard got soggy from the water and became weak which made them bend so i wish i used modroc instead. Next i connected the pincers to the body but this time i used modroc which was far better. I even covered the eye which made it look a lot better in my opinion.